Security, lanyard and lateral Glue

Hi, i buy 2 trezor one and at the moment of open them i notice something.
I open the first one and y see that the glue of the box is correct where the trezor security bands are but in the lateral side (left side seeing the box from the front) the glue is not the same. In the top and botom face it looks like a doble side tape and the other is like a regular glue. I tried opening the second one from that side and its easy to make it look as a new one.
Other thing that i look is that they don’t have the lanyard.
Is this normal or i should buy a new one?


Glue residue is normal, lanyard is not part of the packaging anymore.

Your Trezor is safe. There are a few security measurements with Trezor that can be checked:

  • The USB port of Trezor T should have been covered by a security hologram sticker. With Trezor One, the security hologram is placed on the box.

  • All Trezor devices are distributed without a firmware software, so you need to install it for your first use. If there is a firmware installed already, then that means that someone used this device before you.

  • The bootloader verifies the firmware signature. The device only runs if the firmware is correctly signed by SatoshiLabs.

  • Because the recovery seed is generated during Trezor setup, there is no default seed, only the seed you will generate for yourself. If you encounter any Trezor device with preinstalled firmware that was purchased as new, please let us know